phone : +603 - 7804 8333 / 8118 / 2911
banner_1 banner_2 banner_3 banner_4 banner_5 banner_6 banner_7
  • Induction heater TIH 100m
Medium bearing heater with high heating capacity of up 
to 120 kg bearing
  The SKF medium induction heater TIH 100m has the same high standards of efficiency and performance as the smaller heater TIH 030m, combined with increased capacity. The advanced design of the power electronics allows features of accurate electric current control, cut-outs to avoid overheating, controls on rate of temperature increase, these are as some of the standard features in the TIH...m range.
Placing the induction coil outside the heater’s housing allows the heating of bearings weighing up to 120 kg (264 lb). The heater is equipped with thermal overheating protection to reduce the risk of damage to the induction coil and the electronics. In addition to temperature mode, the TIH 100m is equipped with a time mode for heating components other than bearings. The heater is supplied standard with three yokes and is available in two executions: 230V/50-60Hz or 400-460V/50-60Hz.  
Standard swivel arm for large size yoke
Capable of heating a 97 kg (213 lb) bearing in less than 20 minutes, saving time and energy
2-step power setting and smaller yokes allow heating smaller bearings safely and at lower power consumption
Temperature mode pre–set at 110 °C (230 °F) to help prevent bearing over–heating
Automatic demagnetisation
3 years warranty

  SKF m20 concept
"m20" represents the weight (kg) of the heaviest SRB 231 bearing which can be heated from 20 to 110 °C (68 to 230 °F) in 20 minutes. This defines the heater’s power output instead of its power consumption.

Write a review

Note: HTML is not translated!
    Bad           Good

Induction heater TIH 100m

  • Product Code:
  • Availability: In Stock

Our Brands